Half/Full Duplex

[pakman]

I've got two phones that when I looked at the config originally were set to half duplex under the Hardware Config section. I changed them to H/Full but when I save the changes and reboot and look at the port settings it only show half. Now the switch is setup to auto negotiate and I know this is working fine as I can plug in another phone and it boots up just fine and when I look at that phones Hardware Config section it shows it's Full Duplex under the LAN settings. Is there anything else I could try or maybe these two phones NICS are just shoot?

thanks,

[jrg0852]

Try making the phone "Auto" and see if it takes on the hadshake from the POE switch.

[pakman]

The phone is already set to auto for the port negotiation.

[acejavelin]

Did you try to factory default the phone via the menu?

[pakman]

Yes, I tried that.

[acejavelin]

I saw this once... The fix was to flash it to another PBX & version (I have access to lots of different Mitel PBXs, in this case I used a newer 5000 system), then bring it back and let it reflash to the 3300 it was originally for. Otherwise I gotta go with a bad phone.

[pakman]

Thanks for the suggestion, I don't have another version but I will try taking it back and plugging it into another PBX to see what happens. Otherwise that was also my conclusion.

Thanks,