« previous next »
Pages: [1]   Go Down

Author Topic: Laptop setup  (Read 2122 times)

Offline notserp

  • New Member
  • *
  • Posts: 2
  • Karma: +0/-0
    • View Profile
Laptop setup
« on: October 21, 2011, 10:44:37 AM »
How do I setup my laptop to log-on and communicate with a stand alone and unused MN3300 for practice.

Thanks in advance
Logged

Offline ralph

  • Mitel Forums Admin
  • Hero Member
  • *****
  • Posts: 5767
  • Country: us
  • Karma: +469/-0
  • Published Author: http://amzn.to/2dcYSY5
    • View Profile
Re: Laptop setup
« Reply #1 on: October 21, 2011, 11:11:48 AM »
You'll need to figure out what IP address the 3300 is.
Then set your laptop to be in the same subnet.

To figure out the IP address you may have to shut it down, connect a serial cable to it at 9600,8,N,1 and watch it boot.
You can stop it when it starts it countdown and says "press space bar".
Once it's stopped, enter 'c' and then just step through the settings by hitting 'enter'.

Ralph
« Last Edit: April 23, 2014, 02:08:12 PM by ralph »
Logged

Offline MitelUK2010

  • Sr. Member
  • ****
  • Posts: 201
  • Country: gb
  • Karma: +0/-0
    • View Profile
Laptop setup
« Reply #2 on: October 21, 2011, 04:06:25 PM »
Rather than rebooting can't he do a version?
Logged

Offline ralph

  • Mitel Forums Admin
  • Hero Member
  • *****
  • Posts: 5767
  • Country: us
  • Karma: +469/-0
  • Published Author: http://amzn.to/2dcYSY5
    • View Profile
Re: Laptop setup
« Reply #3 on: October 21, 2011, 04:42:05 PM »
True.
He could use the serial cable and do ChangeBoot.    That would be better.

Ralph
Logged

Offline notserp

  • New Member
  • *
  • Posts: 2
  • Karma: +0/-0
    • View Profile
Re: Laptop setup
« Reply #4 on: October 23, 2011, 03:28:56 PM »
Thanks Guys, much appreciated
Logged

Pages: [1]   Go Up
« previous next »
 

Sitemap 1 2 3 4 5 6 7 8 9 10