Author Topic: Refresher on check list when powering down the 3300  (Read 2635 times)

Offline mgodinez

  • Jr. Member
  • **
  • Posts: 51
  • Karma: +0/-0
    • View Profile
Refresher on check list when powering down the 3300
« on: April 15, 2010, 04:50:30 PM »
Dear Greater Mitel Intellect,

I know how to gracefully shutdown the Mitel 3300ICP.  But I recall something about the verifying something about the DBMS.  Otherwise on reboot, the database would be gone.

Also, is there a way to gracefully shut down the NSU? 

Regards,

Mike G.
Seattle, WA


Offline Chakara

  • Hero Member
  • *****
  • Posts: 607
  • Karma: +2/-0
    • View Profile
    • Kyle Petree
Re: Refresher on check list when powering down the 3300
« Reply #1 on: April 15, 2010, 07:57:57 PM »
  I don't know if this is still true, but when you first load up a 3300 you had to do a DBMS Save command.  Without this it would revert back to the default database on a reboot.  It was a one time thing.

  You can use IMAT to reboot (and I think shutdown) and NSU.

-Chak

Offline bobcheese

  • Sr. Member
  • ****
  • Posts: 435
  • Karma: +3/-0
    • View Profile
Re: Refresher on check list when powering down the 3300
« Reply #2 on: April 16, 2010, 03:36:36 AM »
enter the command dbms stat. When the screen display is outputted check the field 'dbms_initialized' if set to 'on' then when you reboot the db will be resotred. If set to off when the system is rebooted the db is cleared and a default (blank) database will be loaded.

Offline Mitel100

  • Sr. Member
  • ****
  • Posts: 262
  • Country: gb
  • Karma: +6/-0
    • View Profile
Re: Refresher on check list when powering down the 3300
« Reply #3 on: April 16, 2010, 05:46:47 AM »
With the NSU, you can use the restart command and then stop the boot sequence when prompted. I do not know of a shutdown command on the NSU, but could be wrong.


 

Sitemap 1 2 3 4 5 6 7 8 9 10