Author Topic: Vx Works doesnot work  (Read 1319 times)

Offline gimitel

  • Sr. Member
  • ****
  • Posts: 205
  • Karma: +0/-0
    • View Profile
Vx Works doesnot work
« on: May 11, 2015, 07:16:48 PM »
Guys in my previous topic I mentioned that when I power up the Mitel 3300 Cxi the only two led that are continuously on is the alarm and the power. Both remains red. Doesnot flicker at all.
Connect my laptop to the serial port to see what info I can see on the Vx Works, but I am not getting anything. Connect my laptop to another switch to make sure that my setting on the serial port is correct, but on the other switch I am getting Vx Works info.

Can someone help with some info what might or what is defect?

Thanks

Gimitel


Offline johnp

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 2202
  • Country: us
  • Karma: +66/-0
    • View Profile
Re: Vx Works doesnot work
« Reply #1 on: May 11, 2015, 08:48:06 PM »
Sounds like a bad drive or bad boot parameters

Offline lundah

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1216
  • Country: us
  • Karma: +66/-0
  • Senior Chief Grunt
    • View Profile
Re: Vx Works doesnot work
« Reply #2 on: May 12, 2015, 11:14:18 AM »
If you plug into the serial port before powering up, then power up the controller, do you see the boot info and POST tests? If not, more than likely your controller (or perhaps just the power supply) is bad.


 

Sitemap 1 2 3 4 5 6 7 8 9 10