Author Topic: Dynamic Extension Stops working  (Read 2249 times)

Offline jowilkins

  • New Member
  • *
  • Posts: 3
  • Karma: +0/-0
    • View Profile
Dynamic Extension Stops working
« on: November 12, 2021, 06:05:00 PM »
Using MiVoice Office 250.

Have a dynamic extension setup
Step 1) Goes to Desk 1 "an 5330" on site and Desk 2 "another 5330" off site at the same time, if no answer after 24 seconds
Step 2) Ring to VM.

Works okay for a while, then poof it breaks. Desk 2 requires removal and re-add. Works for a while and poof it breaks again. Its a vicious cycle.

Anyone seen this issue have any insight?
« Last Edit: November 12, 2021, 06:47:08 PM by jowilkins »


Offline Tech Electronics

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 2978
  • Country: us
  • Karma: +87/-1
    • View Profile
Re: Dynamic Extension Stops working
« Reply #1 on: November 12, 2021, 07:06:13 PM »
jowilkins,

When you go to Associated Destinations under that User Profile do you see the non-working device as active?

Thanks,

TE


Offline jowilkins

  • New Member
  • *
  • Posts: 3
  • Karma: +0/-0
    • View Profile
Re: Dynamic Extension Stops working
« Reply #2 on: November 15, 2021, 01:38:19 PM »
I am not sure what you mean by "active", Its still showing up there at the moment. I am not the only one that works on this, so I will have to see if anyone has noticed.

Offline Tech Electronics

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 2978
  • Country: us
  • Karma: +87/-1
    • View Profile
Re: Dynamic Extension Stops working
« Reply #3 on: November 16, 2021, 07:55:57 AM »
jowilkins,

Hmm, well if you go to where I explained to look then you should see if it is in the column field that shows, "Active".

System > Users > {User Profile} > Associated Destinations: you should see all of the devices and what their status is; see the attached example picture.

Thanks,

TE

Offline jowilkins

  • New Member
  • *
  • Posts: 3
  • Karma: +0/-0
    • View Profile
Re: Dynamic Extension Stops working
« Reply #4 on: November 19, 2021, 10:58:58 AM »
Yes, the destination that isn't working, shows as active.

Offline Tech Electronics

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 2978
  • Country: us
  • Karma: +87/-1
    • View Profile
Re: Dynamic Extension Stops working
« Reply #5 on: November 25, 2021, 10:33:51 AM »
jowilkins,

It sounds as though the person is turning off their DEE either intentionally or unintentionally.

Look under System > Devices and Feature Codes > Feature Codes:
Dynamic Extension Express Off [Default: 362]
Dynamic Extension Express On [Default: 363]
Dynamic Extension Express On/Off [Default: 364]

If the first and last one are area/office codes in your area then most likely they are dialing without dialing the Outgoing Feature Code and turning on and off features.

You could add a digit to the feature code or force them to use the special key to use feature codes.

Thanks,

TE


 

Sitemap 1 2 3 4 5 6 7 8 9 10