Author Topic: View Outpulsed Digits Sent to CO - MiVO 250  (Read 770 times)

Offline CLI_ninja

  • Contributer
  • *
  • Posts: 6
  • Country: us
  • Karma: +0/-0
    • View Profile
View Outpulsed Digits Sent to CO - MiVO 250
« on: August 29, 2019, 12:24:31 PM »
Hello, I'm playing around with ARS and would like to see what digits are getting sent to the CO....is there anywhere to view via the SAD tool?  Or, any other method?


Offline Tech Electronics

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 2978
  • Country: us
  • Karma: +87/-1
    • View Profile
Re: View Outpulsed Digits Sent to CO - MiVO 250
« Reply #1 on: August 29, 2019, 12:37:41 PM »
CLI_ninja,

That all depends on what type of trunking you have associated with that CO Trunk Group.

If it is an ISDN type trunk then you will need to get into Command Line of the controller and run the ISDN Diagnostics and then you see what it is sending out for data.

If it is SIP then you just need to turn on the SIP Logging and you can see what it is sending out within the SA&D tool.

If it is a Loop Start Trunk then you will need to get a digit grabber and hook it up.

Thanks,

TE

Offline CLI_ninja

  • Contributer
  • *
  • Posts: 6
  • Country: us
  • Karma: +0/-0
    • View Profile
Re: View Outpulsed Digits Sent to CO - MiVO 250
« Reply #2 on: August 29, 2019, 01:11:29 PM »
Tech Electronic....thank you.  This is PRI.  D-Channel Diag revealed one of my digits was getting truncated. 


 

Sitemap 1 2 3 4 5 6 7 8 9 10