Actually this is a continuation of our conversation, I started topic in August:
Re: Paging from different Controller
« Reply #1 on: August 20, 2012, 08:06:42 PM »
Quote
Yes. You just can mix the page groups.
Easy way to do it is to dial the Cluster Element Access code then the page code and page group. <CE><FAC><Group>
Ralph
--------------------------------------------------------------------------------
martyn
Global Moderator
Sr. Member
Posts: 252
Karma: +2/-0
[applaud][smite]
Bachelor Degree Majoring in beer consumption
Re: Paging from different Controller
« Reply #2 on: August 20, 2012, 08:48:53 PM »
Quote
Quote from: ralph on August 20, 2012, 08:06:42 PM
Yes. You just can mix the page groups.
Easy way to do it is to dial the Cluster Element Access code then the page code and page group. <CE><FAC><Group>
Ralph
Make sure you do it as a speed dial though, as otherwise the users will never get it right and you will have paging all over the shop!
Report to moderator Logged
--------------------------------------------------------------------------------
xrds
Jr. Member
Posts: 30
Karma: +0/-0
Re: Paging from different Controller
« Reply #3 on: August 21, 2012, 03:19:43 PM »
Quote
Do I have to create a Cluster Element Code and Page Codes, I already know what the page group numbers are?
Report to moderator 76.79.238.82
--------------------------------------------------------------------------------
martyn
Global Moderator
Sr. Member
Posts: 252
Karma: +2/-0
[applaud][smite]
Bachelor Degree Majoring in beer consumption
Re: Paging from different Controller
« Reply #4 on: August 21, 2012, 06:50:43 PM »
Quote
Each 3300 in the cluster will already have a Cluster Element ID (CEID) that you can dial to get features across cluster members. You will also have a Feature Access Code (FAC) programmed for paging.
So for example your speed dial might be 4000 which points to 5001**91 - with 5001 being the CEID, **9 being the FAC for loud speaker paging on that system, and 1 is the group number.
Report to moderator Logged
-------------------------------------------------------------------------------
martyn
Global Moderator
Sr. Member
Posts: 252
Karma: +2/-0
[applaud][smite]
Bachelor Degree Majoring in beer consumption
Re: Paging from different Controller
« Reply #5 on: August 21, 2012, 06:55:16 PM »
Quote
Actually I should correct myself, as I have just looked at my notes.
On the system that has the PA attached create a speed call (3000 for example) that points to the FAC for loud speaker paging (eg. **9#)
On the system that you want to page from create a speed dial that points to the SC created above on the remote system, but you have to include the CEID of the remote system. EG. 4000 (SC) points to 50013000 - with 5001 being the CEID and 3000 being the SC on the remote system.
You must also check your COS for the IP trunk between the controllers to make sure that paging is allowed on the trunk as well.
Report to moderator Logged
--------------------------------------------------------------------------------
xrds
Jr. Member
Posts: 30
Karma: +0/-0
Re: Paging from different Controller
« Reply #6 on: October 19, 2012, 06:47:51 PM »
Quote
I've been looking, but can't find where the IP Trunks are for the 3 Controllers we have, might they be listed under a different name like(PBX Number/Cluster Element ID) under the Voice Network category?
I need to find them to be able to change COS and/or COR. Thanks.
