Messages

1

Mitel MiVoice Business/MCD/3300 / Re: How to add extension to hunt group member

« on: August 23, 2012, 07:32:22 PM »

Thanks everyone! This forum is a great resource!

My next project is figuring out Class of Service and Class of Restriction but I'll start a new thread once I've had a chance to look into it and come up with some specific questions!

Thanks again ralph, bluewhite4 and bobcheese!!!

2

Mitel MiVoice Business/MCD/3300 / Re: How to add extension to hunt group member

« on: August 20, 2012, 08:54:06 PM »

Thanks Ralph! That did it! Much appreciated!

I am curious about the different Ring Type options though... "ring" and "no ring" seem fairly obvious but does anyone know about the others?

Delay Ring - can you configure the delay at all?
Ring Cont - I assume cont means continuous? What does that mean in practice?
Delay Ring Cont - The answer to the previous will help explain this too I suppose?

Anyway, thanks again for the help ralph and bobcheese!

3

Mitel MiVoice Business/MCD/3300 / Re: How to add extension to hunt group member

« on: August 15, 2012, 02:10:29 AM »

@bobcheese
Command:
LOCATE NUMBER 7801
System Response:
The number refers to a Non Prime Broadcast Group.

@ralph
Receptionist has a 5324 (I think) with another bank of buttons attached to the side for extensions. I'm not actually sure how many lines she has. The reason for adding someone to the hunt group is that the boss's PA would like her phone to ring also when reception is busy/unattended.

Thanks both for responding!

Matt

4

Mitel MiVoice Business/MCD/3300 / How to add extension to hunt group member

« on: August 13, 2012, 10:56:00 PM »

Hi,

Apologies if this is a very basic question but currently when our main reception number gets called if it is not answered within a set period of time it starts to ring on additional extensions in the office. I would like to add an additional extension that will also ring. I could be wrong but I think what I am describing is a hunt group.

Our reception extension is 800 and I can see that hunt group 800 is in "Circular" mode. I can also see that that hunt group has three members whose numbers are 7801, 7802 and 7803.

Those numbers appear to be "group" extensions of some sort but even after looking through all the forms alphabetically I can't figure out where they are configured or how to add another extension to one...

I could probably try to add the individual extension in to the hunt group directly but I would rather add it to one of the existing "group" extensions so that it rings at the same time as other members of that group.

Thanks in advance for any assistance!

Matt

Edit: I'm not sure what is relevant but I meant to add that we have a 3300 CX. Mitel Communications Director "About" tells me we are on Release Level 4.0 with Active software load 10.0.0.10_2