Messages

1

Mitel MiVoice Business/MCD/3300 / Re: Checking call volume via SNMP

« on: August 19, 2014, 08:12:09 AM »

Excellent - thanks guys, I will investigate further.

2

Mitel MiVoice Business/MCD/3300 / Re: Checking call volume via SNMP

« on: August 18, 2014, 02:05:54 AM »

Apparently one way to do this is to use CCM - there's a report called something like trunk usage or something.

Also, the command I wrote about earlier actually tells you how many inbound lines are configured on the PBX, which may not correlate to the number you actually have.

A better command is to look at the outbound lines: STATE trunk GROUP 1

3

Mitel MiVoice Business/MCD/3300 / Re: Checking call volume via SNMP

« on: August 15, 2014, 02:50:21 AM »

My support partner has provided the following MIBs (attached).

Not sure what I should be looking for, but if I find it, I will post the results.

Any advice greatly appreciated.

4

Mitel MiVoice Business/MCD/3300 / Checking call volume via SNMP

« on: August 11, 2014, 11:20:18 PM »

Does anyone know what OIDs I would need to poll via SNMP to determine the number of lines that are in use?

I know that I can run the following command to generate the report I want via the web interface, but I want to tie this into Zabbix so we can get historical data.
Logon to the Mitel and open the Systems Administration Page
Open the Maintenance & Diagnostics menu item
Click on the Maintenance Commands menu item
Type the following: STATE 2 1 2 1