Author Topic: DSP Alarm on MXeIII  (Read 1980 times)

Offline brogerson

  • Full Member
  • ***
  • Posts: 100
  • Country: ca
  • Karma: +1/-0
    • View Profile
DSP Alarm on MXeIII
« on: October 27, 2016, 09:26:55 AM »
I just put in a new MXe III at a site with 90 IP Phones, 111 Mailboxes with and Embedded PRI card.  I have a minor DSP alarm telling me I have 5 DSP's and one is unavailable.

The DSP Status maintenance command shows there are 4 DPS and all are available,  I believe the PRI has a DSP which could be causing the alarm but I am not sure.



Offline lundah

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1216
  • Country: us
  • Karma: +66/-0
  • Senior Chief Grunt
    • View Profile
Re: DSP Alarm on MXeIII
« Reply #1 on: October 27, 2016, 09:39:25 AM »
The controller has 1 built-in DSP module that shows up as slot 7. Compare the "Show Status DSP" with the Hardware Modules form to see which one is not coming up. I normally try a reboot before replacing the bad module, sometimes that takes care of the alarm.

Offline petr.necas

  • Sr. Member
  • ****
  • Posts: 393
  • Country: cz
  • Karma: +8/-0
    • View Profile
Re: DSP Alarm on MXeIII
« Reply #2 on: October 27, 2016, 09:58:24 AM »
In our CXi demokit we have no SDP modules installed but have 8 Compression licenses, unless we set the number of used Compression licenses to 0, we have minor "DSP status" alarm.

Offline brogerson

  • Full Member
  • ***
  • Posts: 100
  • Country: ca
  • Karma: +1/-0
    • View Profile
Re: DSP Alarm on MXeIII
« Reply #3 on: October 27, 2016, 01:13:35 PM »
The Show Status DSP command shows all four DSP's are available, reboots and Upgrade BootRom have not cleared the Alarm.

There are 8 Compression Licenses but none are in use and there were only three sets in a Compression zone that have been changed back to Default and the compression programming has been cleared.

Offline johnp

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 2202
  • Country: us
  • Karma: +66/-0
    • View Profile
Re: DSP Alarm on MXeIII
« Reply #4 on: October 28, 2016, 05:25:20 PM »
There is one dsp on the resilient T1 single framer. At least their used to be from the early days.

Offline brogerson

  • Full Member
  • ***
  • Posts: 100
  • Country: ca
  • Karma: +1/-0
    • View Profile
Re: DSP Alarm on MXeIII
« Reply #5 on: October 31, 2016, 01:24:22 PM »
I believe there is a DSP on the Combo card but this one is a Dual Framer


 

Sitemap 1 2 3 4 5 6 7 8 9 10