DSP Alarm on MXeIII

[brogerson]

I just put in a new MXe III at a site with 90 IP Phones, 111 Mailboxes with and Embedded PRI card.  I have a minor DSP alarm telling me I have 5 DSP's and one is unavailable.

The DSP Status maintenance command shows there are 4 DPS and all are available,  I believe the PRI has a DSP which could be causing the alarm but I am not sure.

[lundah]

The controller has 1 built-in DSP module that shows up as slot 7. Compare the "Show Status DSP" with the Hardware Modules form to see which one is not coming up. I normally try a reboot before replacing the bad module, sometimes that takes care of the alarm.

[petr.necas]

In our CXi demokit we have no SDP modules installed but have 8 Compression licenses, unless we set the number of used Compression licenses to 0, we have minor "DSP status" alarm.

[brogerson]

The Show Status DSP command shows all four DSP's are available, reboots and Upgrade BootRom have not cleared the Alarm.

There are 8 Compression Licenses but none are in use and there were only three sets in a Compression zone that have been changed back to Default and the compression programming has been cleared.

[johnp]

There is one dsp on the resilient T1 single framer. At least their used to be from the early days.

[brogerson]

I believe there is a DSP on the Combo card but this one is a Dual Framer