Author Topic: MCD Netsync Summary info  (Read 2107 times)

Offline mszodiac

  • Sr. Member
  • ****
  • Posts: 232
  • Country: ca
  • Karma: +7/-0
    • View Profile
MCD Netsync Summary info
« on: May 26, 2015, 02:50:06 PM »
Hi Everyone.  One of our MCD 3300 was showing a lot of this:

MTNETSNC disable netsync source link 0 requested MTNETSNC select clock sync for link 0 health is PASSED MTNETSNC switching to long term accumulator mode for link 0 Change in network synchronizing source from source 02 to source 01 Justification : New synchronizing source has just become available

The logs cleared after swapping sync sources.

Can someone explain the correct specs of the control range? This particular MCD shows only 92% where the others show 99%.  The help files say if the control range is low, then the system clock might be a problem.  But it doesn't specify the minimum range.  Thanks!

 Time           |         | single | phase | control    |                                 
start  end     | act    |  hits   | shifts  | range % | sync sources used               
--------------+------+--------+-------+----------+------------------               
14:18 14:41 | ACT  |     0     |    0   | 92 - 92    | 1                         


 

Sitemap 1 2 3 4 5 6 7 8 9 10