Hi Everyone. One of our MCD 3300 was showing a lot of this:
MTNETSNC disable netsync source link 0 requested MTNETSNC select clock sync for link 0 health is PASSED MTNETSNC switching to long term accumulator mode for link 0 Change in network synchronizing source from source 02 to source 01 Justification : New synchronizing source has just become available
The logs cleared after swapping sync sources.
Can someone explain the correct specs of the control range? This particular MCD shows only 92% where the others show 99%. The help files say if the control range is low, then the system clock might be a problem. But it doesn't specify the minimum range. Thanks!
Time | | single | phase | control |
start end | act | hits | shifts | range % | sync sources used
--------------+------+--------+-------+----------+------------------
14:18 14:41 | ACT | 0 | 0 | 92 - 92 | 1
