« previous next »
Pages: [1]   Go Down

Author Topic: MXE III hard drive failure (SATA)  (Read 2207 times)

Offline jrg0852

  • Sr. Member
  • ****
  • Posts: 309
  • Country: us
  • Karma: +3/-0
  • Look out for the next tech. because it may be you!
    • View Profile
MXE III hard drive failure (SATA)
« on: August 29, 2014, 02:43:24 PM »
Hi, ya'll. I have a tkt. open with Mitel, but would also like to get some field feedback (the best kind). So, I have a HD (HD#2) at a client that has a bad sector. I tried clearing the sockets, re-raiding. The Raid went through successful only to get the same error. I have changed the sub system card (raid controller) to no avail. I am changing the HD on Tuesday. Hopefully this will do it. Any feedback on anyone else running into this? Thanks in advance.
Logged

Offline jrg0852

  • Sr. Member
  • ****
  • Posts: 309
  • Country: us
  • Karma: +3/-0
  • Look out for the next tech. because it may be you!
    • View Profile
Re: MXE III hard drive failure (SATA)
« Reply #1 on: September 02, 2014, 08:24:48 AM »
It ended up being the 2nd HD. A note on clearing the sockets. Give it more time than they say. Let it go for 10 minutes without any drives in. Then power off. Insert the 1st HD (#1). Power back on. Allow system to come up FULLY. Insert HD#2. The raid begins automatically. Typically takes 1 to 1 1/2 hours to complete. Keep running the SHOW STATUS RAID command to see the process. Thanks.
Logged

Pages: [1]   Go Up
« previous next »
 

Sitemap 1 2 3 4 5 6 7 8 9 10