Secure Active Directory sync not working to 2008R2 DC

[pmhaynes]

Trying to setup active directory sync to a 2008r2 DC
Works unsecure method but not secure
Error message says unable to connect
Logs say same so no point attaching them
Tried on 389 636 tls and ssl
Tried by name and IP
Name of DC does resolve OK from console

Tried different credentials including GOD account

I have seen this working before i dont remeber any problems

We have CA installed on the AD also

Mitel support did not have any gems of wisdom

Server is in server gateway with MBG

Any ideas?

[akuhn]

Are they on the same subnet?  It sounds like they are not.  If not, I would suggest, just for testing, opening all ports between the domain controller and the PBX.  That way, we can determine whether it's a port issue or not.

[martyn]

Can you telnet to the DC IP address with those ports from the voice network?

If you are using SSL, is there a trust between the two?

[pmhaynes]

I can telnet on the none secure port. When I do it waits for an input then disconnects.
That's probably right

On the secure port it seems to connect then disconnect but with out ant input

Again that would not surprise me to be normal behaviour



I can ask the providers of the MPLs what, if any, ports are blocked


Thx guys


Sent from my iPhone using Tapatalk

[pmhaynes]

This was working on my next visit. I think the DC server had been rebooted