Author Topic: Phone doesn't automatically select a line when receiver is lifted  (Read 2568 times)

Eyepodder

  • Guest
Phone doesn't automatically select a line when receiver is lifted
« on: September 28, 2009, 10:57:15 AM »
We have a superset 420 that when we pick up the receiver we have manually select the line to use. How do I configure the phone to automatically select the line to use. The person who had this office had it setup for headset which I think is causing the problem but I did a move swap so his phone is in another office but it seems like port is configured still.

Sorry for the dumb question but I inherit this job with no training..


Offline ralph

  • Mitel Forums Admin
  • Hero Member
  • *****
  • Posts: 5767
  • Country: us
  • Karma: +469/-0
  • Published Author: http://amzn.to/2dcYSY5
    • View Profile
Re: Phone doesn't automatically select a line when receiver is lifted
« Reply #1 on: September 28, 2009, 11:01:19 AM »
see if the headset feature is turned on on that phone.
Go the maintenance commands and type "loc fe ex <extn of phone>"   it will show you what features are active.
If headset=on, go to the feature code assignment form, find the headset off feature code and enter it on the phone.   
If there is no feature code, add a headset button to the phone and then toggle it.

Ralph

« Last Edit: April 22, 2014, 03:02:27 PM by ralph »

Eyepodder

  • Guest
Re: Phone doesn't automatically select a line when receiver is lifted
« Reply #2 on: September 28, 2009, 11:06:58 AM »
Thanks that fixed it. No headset assigned. Programming the key for headset then removing it fix the problem.

thanks again.



 

Sitemap 1 2 3 4 5 6 7 8 9 10