Author Topic: Autoboot failed  (Read 2180 times)

Offline greg.kosa

  • New Member
  • *
  • Posts: 2
  • Country: gb
  • Karma: +0/-0
    • View Profile
Autoboot failed
« on: January 22, 2014, 12:01:19 PM »
Hi,

Can someone tell me what's the meaning of this error message?

MIPS *** Autoboot: Trying device 'eth0' file 192.168.1.2:vmlinuz (eth0,tftp) ***
MIPS *** Autoboot failed ***

This message keeps popping up in the logs after a reboot, then after about 40 minutes

MIPS *** Autoboot: Trying device 'eth0' file 192.168.1.2:vmlinuz (eth0,tftp) ***

And no failed message appearing after.
Thanks in advance, best regards.


Offline jrg0852

  • Sr. Member
  • ****
  • Posts: 309
  • Country: us
  • Karma: +3/-0
  • Look out for the next tech. because it may be you!
    • View Profile
Re: Autoboot failed
« Reply #1 on: January 22, 2014, 12:23:11 PM »
Out of curiosity, are your 2 LAN ports set the same as the voice switch you are connecting to? Almost sounds like it doesn't like the handshake.

Offline greg.kosa

  • New Member
  • *
  • Posts: 2
  • Country: gb
  • Karma: +0/-0
    • View Profile
Re: Autoboot failed
« Reply #2 on: January 22, 2014, 12:55:44 PM »
Thanks for your reply. Could you be more specific please? Which 2 LAN ports do you mean? What type of handshake are you referring to?

Offline jrg0852

  • Sr. Member
  • ****
  • Posts: 309
  • Country: us
  • Karma: +3/-0
  • Look out for the next tech. because it may be you!
    • View Profile
Re: Autoboot failed
« Reply #3 on: January 22, 2014, 04:36:04 PM »
I see from Tek-Tips that this is a Cxi. I would make sure all of the ports (the built in ones and LAN) match the voice switch you said you are connecting to.


 

Sitemap 1 2 3 4 5 6 7 8 9 10