make busy

[capitalZ]

i have run a make busy on a bri port for testing purposes, however i am unable to reset it, or atleast release the busy condition. any ideas? CX Mcd 5

[acejavelin]

Try physically disconnecting the circuit, then in Maintenance Commands issue "RTS <PLID>" followed by "FORCE", then reconnecting the circuit. If that fails, what does a STAT <PLID> show?

[ralph]

then in Maintenance Commands issue "RTS <PLID>" followed by "FORCE",

Ace,
Did you mean the command "Busy <PLID>" followed by "force"?

Ralph

[acejavelin]

then in Maintenance Commands issue "RTS <PLID>" followed by "FORCE",

Ace,
Did you mean the command "Busy <PLID>" followed by "force"?

Ralph

Don't think so... I assumed it was already in a busy condition from the OP. Although, a BUSY, followed by FORCE, then a RTS might be applicable here.