Author Topic: Check/monitor lines in use?  (Read 7325 times)

Offline boxman80

  • New Member
  • *
  • Posts: 2
  • Karma: +0/-0
    • View Profile
Check/monitor lines in use?
« on: September 14, 2012, 09:31:50 AM »
Hi all, sorry for the newbie question but is it possible for me to check or monitor the use of incoming/outgoing lines?

We have an ISDN30 with 15 lines shared between 2 resileint 3300's and I suspect that thre is an issue whereby we are only actually getting 15 of those line at any 1 time. I would like to know how to investiage our line usage and even see in realtime the amount of lines in use at any particulat time (particularly when my users are getting the "busy" message when trying to dial out).



Offline Mattmayn

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1069
  • Country: vi
  • Karma: +14/-0
    • View Profile
Re: Check/monitor lines in use?
« Reply #1 on: September 14, 2012, 10:41:36 AM »
To see realtime usage you can run the maintenance command "stat (PLID of circuit)" and that will give you the status of the channels. If you have any channels that look like they are always busy you can run the "resource (PLID)" command and that will show you what is using that channel.

Offline ralph

  • Mitel Forums Admin
  • Hero Member
  • *****
  • Posts: 5767
  • Country: us
  • Karma: +469/-0
  • Published Author: http://amzn.to/2dcYSY5
    • View Profile
Re: Check/monitor lines in use?
« Reply #2 on: September 14, 2012, 10:44:51 AM »
find out what trunk group the trunks are in.

I'll assume Trunk Group #1 for this example.

In Maintenance Commands enter:  Stat Trunk Group 1

It will show you what trunks are busy or idle.

Also you export your software/maintenance logs into Excel and then do a search for the word "Congestion".
It will show you the number of times all trunks were busy when another call tried to go out.

Ralph


Ralph

Offline jamsignal

  • Contributer
  • *
  • Posts: 10
  • Karma: +0/-0
    • View Profile
Re: Check/monitor lines in use?
« Reply #3 on: October 04, 2012, 03:07:33 PM »
stat trunk group 1
This command does not work on one of my 3300s. No error and no output when I click submit.

Offline ralph

  • Mitel Forums Admin
  • Hero Member
  • *****
  • Posts: 5767
  • Country: us
  • Karma: +469/-0
  • Published Author: http://amzn.to/2dcYSY5
    • View Profile
Re: Check/monitor lines in use?
« Reply #4 on: October 04, 2012, 07:55:21 PM »
Schedule a reboot of that controller.

Ralph


 

Sitemap 1 2 3 4 5 6 7 8 9 10