« previous next »
Pages: [1]   Go Down

Author Topic: Paging Delay  (Read 2419 times)

Offline mx745

  • New Member
  • *
  • Posts: 2
  • Karma: +0/-0
    • View Profile
Paging Delay
« on: June 08, 2012, 12:47:17 PM »
Have a 3300 at one of our locations and they tell me they are getting a delay when they page.  They say its takes about 7 seconds till it allows them to page.  Is there a setting I can change to lower this delay time.  Not seen it in class of service or any other form yet.
Logged

Offline bluewhite4

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1041
  • Country: us
  • Karma: +20/-0
    • View Profile
Re: Paging Delay
« Reply #1 on: June 08, 2012, 12:48:46 PM »
Are they using phone paging or loudspeaker paging? Is this system a CX/MXe/MXe with second processor? How many phones are in the paging group?
Logged

Offline Mattmayn

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1069
  • Country: vi
  • Karma: +14/-0
    • View Profile
Re: Paging Delay
« Reply #2 on: June 08, 2012, 12:54:31 PM »
If loudspeaker, are you using a trunk or the page port?
Logged

Offline mx745

  • New Member
  • *
  • Posts: 2
  • Karma: +0/-0
    • View Profile
Re: Paging Delay
« Reply #3 on: June 08, 2012, 01:41:09 PM »
Loudspeaker paging, and I believe its a page port.  MXe-III and around 60 phones on system.  I didn't set the system up and been thrown into learning the configurartion of it.
Logged

Offline ralph

  • Mitel Forums Admin
  • Hero Member
  • *****
  • Posts: 5767
  • Country: us
  • Karma: +469/-0
  • Published Author: http://amzn.to/2dcYSY5
    • View Profile
Re: Paging Delay
« Reply #4 on: June 08, 2012, 03:52:03 PM »
If they're dialing page codes then have them try <page code>+'#'
I'd suspect a digit conflict and that will prove it out.

Ralph
Logged

Pages: [1]   Go Up
« previous next »
 

Sitemap 1 2 3 4 5 6 7 8 9 10