MiVB 8.0 PR3 checking HDD for errors?

[Crowtalks]

I have a RAID alarm on the 2nd disk and according to a knowledge base article I potentially need to check the 1st disk for sector faults...how do I do this?

from Mitel:

If the alarm occurs on the secondary drive, check
the primary drive for faults. (In some cases, the
primary drive has a sector error while the
secondary drive is fault free.)

(On the RAID array, the left light is blue, what appears to be a center light is not on and the right light is blue) I don't fully recall, but I was thinking that before when I had a bad drive that one of the LEDs was a different color.

Thanks, Jim

[acejavelin]

SHOW STATUS REDUNDANT

[Crowtalks]

Redundant Status:

   Power                Seated    Input  Output Fan     Temp.
   Supply    Installed  Fault     Fault  Fault  Fault   Fault
   ------    ---------  --------  -----  ------ -----  ------
     1          Yes          No     No     No     No     No   
     2          Yes          No     No     No     No     No   

   Fan       Running
   ------    -------
     1          Yes
     2          Yes

   Temperature
   Sensor         Temperature    Alarmed
   ------         -----------    -------
    1                  20          No   
    2                  28          No   

SATA RAID Controller

   Hard                      Disk    Disk
   Disk   Installed   Fault  State   Status
   ----   ----------- -----  ------- ------
     1        Yes     No     Normal  Match.
     2        No      -----  ------- ------

Disk 1 id matches
  Current Model Number  : ST250LT012-1DG141                       
  Expected Model Number : ST250LT012-1DG141                       
  Current Serial Number :             WBY4R3ST
  Expected Serial Number:             WBY4R3ST

Disk 2 id mis-match
  Current Model Number  : Not Applicable
  Expected Model Number : ST250LT012-1DG141                       
  Current Serial Number : Not Applicable
  Expected Serial Number:             WBY6QXEQ

--*-*--