Author Topic: get Micollab client to always run on user login?  (Read 1592 times)

Offline divadiow

  • Contributer
  • *
  • Posts: 13
  • Country: gb
  • Karma: +0/-0
    • View Profile
get Micollab client to always run on user login?
« on: February 10, 2022, 12:24:29 PM »
I know there's the slider under general settings that, when enabled, creates an entry for micollab.exe under the user's HKCU\...run\ key. But how can we enable this in bulk for all users? Registry change? switch on msi installation?

cheers


Offline lundah

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1215
  • Country: us
  • Karma: +66/-0
  • Senior Chief Grunt
    • View Profile
Re: get Micollab client to always run on user login?
« Reply #1 on: February 11, 2022, 08:34:05 AM »
What version? As of 9.3 you can set this in the User Profile.

Offline divadiow

  • Contributer
  • *
  • Posts: 13
  • Country: gb
  • Karma: +0/-0
    • View Profile
Re: get Micollab client to always run on user login?
« Reply #2 on: February 12, 2022, 09:36:43 AM »
ah. it is 9.3.

I couldn't find ref to this in the documentation. forgive me, where's the "user profile"?

Offline lundah

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1215
  • Country: us
  • Karma: +66/-0
  • Senior Chief Grunt
    • View Profile
Re: get Micollab client to always run on user login?
« Reply #3 on: February 14, 2022, 03:00:44 PM »
ah. it is 9.3.

I couldn't find ref to this in the documentation. forgive me, where's the "user profile"?

Last tab of the MiCollab Client Service settings. Use caution with this, you can mess up a lot of users quickly if you're not careful.


 

Sitemap 1 2 3 4 5 6 7 8 9 10