New to MiVB and AX Controller

[jchristman2002]

I did the Mitel MiVB training in 2015 and then again this past December, but we have been doing exclusively MiVoice Office 250 systems and I have not had to touch a MiVB system until now.  I have an AX controller with a DSP II MMC, a T1/E1 MMC, and a 4+12 Combo card.   I am trying to configure an analog extension for a fax machine on the on the 4+12 card and for the life of me I cannot figure out the PLID.   I guess my understanding of this number is all wrong.  We never actually discussed this in class and I have been through the engineer guide, hardware technical manual, general installation guide, technician's handbook, and troubleshooting guide as well as the Primer and for the life of me I am either too dense or missing it somewhere.

If anyone has a quick, this this this way of describing it for me that would be great.  Or at a minimu what would the PLID be for the first analog port on a 4+12 card in the first available slot in an AX controller.

Your help is so appreciated.   

Thanks,
Jon

[johnp]

Under hardware moules asu is there a unit set? If so under card assignment has the card been set?

[jchristman2002]

Yep.  Port 1 Unit 3 AX Card Chasis

[johnp]

Go to users advanced analog sets

[jchristman2002]

Its blank.

[jchristman2002]

forgot to attach

[johnp]

Sure card assignment is filled out?

[jchristman2002]

Bingo.  That is what I missed. 

Thanks for ht help.  On a Sunday no less.