EX Controller Dual IP addresses

[Jimmer_911]

Is there a way to have two separate IP address?  Need to set up a WAN connection and a LAN connection.  WAN is for remote access and the LAN is for the phones only.

During a Putty session you can setup multiple IPs.  System IP and WAN IP and another.  But when creating the LAN and WAN IPs it seems to change the 3300s IP address to the WAN IP but setting the Media Gateway to the LAN.  This causes issue.

I have a ticket opened for this as well, 998655
I was working with Steve on another issue when this came up

[bajangerry]

When you run the EX Controller Deployment tool there is the option to configure the WAN port. This is in the "EX Controller Installation and Administration Guide"

[Jimmer_911]

Yes i am aware of that during the initial install of the system.  But if i want to do it after the install can it be done?  I was not given the information until after deployment.