Author Topic: IP Trunk Calls not working  (Read 1336 times)

Offline brogerson

  • Full Member
  • ***
  • Posts: 100
  • Country: ca
  • Karma: +1/-0
    • View Profile
IP Trunk Calls not working
« on: July 08, 2020, 10:16:20 AM »
I have two systems at 9.0sp3 that has an IP trunk to a system with 7.2 software.

The configuration looks good and the trunk is established.  When I try and make a call across the trunk i get a out of service message on my phone even though the trunk shows established or idle in maintenance.

CCS Trace shows the PBX is not even attempting to make the call.


Offline ralph

  • Mitel Forums Admin
  • Hero Member
  • *****
  • Posts: 5767
  • Country: us
  • Karma: +469/-0
  • Published Author: http://amzn.to/2dcYSY5
    • View Profile
Re: IP Trunk Calls not working
« Reply #1 on: July 08, 2020, 05:13:04 PM »
I've seen something similar and was never able to resolve it.  Even tech support said the config looked right.  I finally gave up and  routed the calls through a third PBX.
Having said that usually the problem is the wrong IP address is programmed in the XNET programming.

Ralph

Offline sunspark

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 986
  • Country: mx
  • Karma: +16/-1
    • View Profile
Re: IP Trunk Calls not working
« Reply #2 on: July 08, 2020, 06:25:58 PM »
Can you tcpdump your call and share the .Pcap?

Offline brogerson

  • Full Member
  • ***
  • Posts: 100
  • Country: ca
  • Karma: +1/-0
    • View Profile
Re: IP Trunk Calls not working
« Reply #3 on: July 10, 2020, 09:29:26 AM »
I have checked the XNET forms and in the newer versions of SW you can't configure the IP's.

Offline sunspark

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 986
  • Country: mx
  • Karma: +16/-1
    • View Profile
Re: IP Trunk Calls not working
« Reply #4 on: July 10, 2020, 02:44:32 PM »
Check your ARS routes

share the Tcp dump

Offline johnp

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 2202
  • Country: us
  • Karma: +66/-0
    • View Profile
Re: IP Trunk Calls not working
« Reply #5 on: July 10, 2020, 04:01:42 PM »
I have had cases where the customer natted beween locations in the firewall instead of routing. All looked good, but would only work after the far end send a call. I think it open a pinhole


 

Sitemap 1 2 3 4 5 6 7 8 9 10