Hi Folks,
I got a replacement 3300CXi controller (old one damaged in shipping) and added the old i-button, t1 card, 512m ram (replacement only came with 256m), APC card and it's hard drive.
The i-button brackets on the replacement chassis, likely refurbished, seemed loose, and did not hold the button tight. I bent them a bit, so they hold it tighter.
Anyway, I get the following error message from the maintenance port as soon as I apply power: (it doesn't go any further.) Any ideas??
ERROR - Failed to receive acknowledge during send command:
I2C Client: 0x50
I2C Register: 0x05
ERROR - Failed Device Address Write in Read command
M
ERROR - Failed to receive acknowledge during send command:
I2C Client: 0x50
I2C Register: 0x05
ERROR - Failed Device Address Write in Read command
M
ERROR - Failed to receive acknowledge during send command:
I2C Client: 0x50
I2C Register: 0x05
ERROR - Failed Device Address Write in Read command
M
