Is there a step by step solution to adding a new fax line to an ASU II? I've brought the wiring into the server closet.
I've picked an unused extension to use for the analog extension.
I see where other analog lines have been punched down to a 110 block.
I can go into the MCD > Analog Sets and see where lines are programmed in.
I can see that the circuit IDs end at Cabinet 3, Shelf 1, Slot 1, Circuit 6. So I'd assume I'd add in an extension Cabinet 3, Shelf 1, Slot 1, Circuit 7.
Where would I put that on the block? (see attached photo)
Would I use Circuit 7?
Why is there a pair of wires on the right? (See circled area.) I would think the list of lines would have a gap.
Any help so I can set up this fax line is appreciated, thank you.
Scott
