« previous next »
Pages: [1]   Go Down

Author Topic: Network a Mitel 5000 to a Cisco system  (Read 2196 times)

Offline jmarx33

  • Contributer
  • *
  • Posts: 21
  • Country: us
  • Karma: +0/-0
    • View Profile
Network a Mitel 5000 to a Cisco system
« on: January 08, 2015, 01:32:41 PM »
Has anybody try and network a 5000 to a cisco call manager?
Logged

Offline Tech Electronics

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 2983
  • Country: us
  • Karma: +89/-1
    • View Profile
Re: Network a Mitel 5000 to a Cisco system
« Reply #1 on: January 13, 2015, 10:51:08 AM »
JMarx33,

What type of networking were you looking to do?

Sorry for the late reply,

TE
Logged

Offline jmarx33

  • Contributer
  • *
  • Posts: 21
  • Country: us
  • Karma: +0/-0
    • View Profile
Re: Network a Mitel 5000 to a Cisco system
« Reply #2 on: January 20, 2015, 09:35:07 AM »
I think it would be sip to connect the 5000 to the cisco.
Logged

Offline IPInstaller

  • Jr. Member
  • **
  • Posts: 77
  • Country: gb
  • Karma: +1/-0
    • View Profile
Re: Network a Mitel 5000 to a Cisco system
« Reply #3 on: January 22, 2015, 04:55:11 AM »
I agree that SIP will be the way to do this.

I just wondered if anyone had tried it.
Logged

Offline Tech Electronics

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 2983
  • Country: us
  • Karma: +89/-1
    • View Profile
Re: Network a Mitel 5000 to a Cisco system
« Reply #4 on: January 22, 2015, 10:00:42 AM »
Jmarx33,

Well I have done it via T-1, but if you are wanting to do it with SIP I don't have an answer.

Sorry,

TE
Logged

Offline hriaz

  • New Member
  • *
  • Posts: 4
  • Country: us
  • Karma: +0/-0
    • View Profile
Re: Network a Mitel 5000 to a Cisco system
« Reply #5 on: February 03, 2015, 03:43:31 PM »
We have done it over SIP however you need to check licensing as the license is per call. Its setup on Mitel side to use feature code 6 + 4 digits. You don't need SIP UA or B2BA

On Cisco router configure the dial peer as follows

dial-peer voice 100 voip
destination-pattern 12.. (Where 12XX is Mitel extensions)
session-target ipv4:x.x.x.x (Mitel IP)
session-protocol sipv2
session-transport tcp
no vad

That should get you started.
Logged

Pages: [1]   Go Up
« previous next »
 

Sitemap 1 2 3 4 5 6 7 8 9 10