Pulse Dialling via P2T Adapter

[smaxwe1]

Hi All,

We've recently installed two new 3300's with 4 ASU's each which will all be used with Modems. We have a need to configure a couple of extensions with Pulse Dialling as the modem is an old POS. When we were down in Mitel's labs we didnt test this modem, but they did suggest a Pulse 2 Tone adapter has been seen to work and we have ordered some of these.

When I plug in a test handset and set this to Pulse dialling, it will dial my mobile / cell OK, but the modem wont dial out and I'm wondering if there is anything anywhere in the system that needs to be tweaked. I've looked at pulling pauses into a system speed call but am yet to test this.

Just wondering if anyoen else has any thoughts they could share? I'm not a Mitel guru, i'm an end user who's had to learn this through necessity, so please bear with me if something doesnt immediately click.

Cheers,

Steve

[jrg0852]

Steve. Try going to ONS/OPS Circuit Desc. You are most likely using the default, which is 1. Change the Part of a Modem to "yes" and see if that helps.

[smaxwe1]

Thanks for the suggestion. I've updated the 'Part of a Modem' and will give it a go.

Cheers,