Author Topic: make busy  (Read 3352 times)

Offline capitalZ

  • Contributer
  • *
  • Posts: 9
  • Karma: +0/-0
    • View Profile
make busy
« on: January 08, 2013, 05:20:49 AM »
i have run a make busy on a bri port for testing purposes, however i am unable to reset it, or atleast release the busy condition. any ideas? CX Mcd 5


Offline acejavelin

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 4099
  • Country: us
  • Karma: +133/-0
  • High-tech, heavy metal redneck!
    • View Profile
    • Like what I do and wanna help out? Send me a donation!
Re: make busy
« Reply #1 on: January 08, 2013, 09:53:30 AM »
Try physically disconnecting the circuit, then in Maintenance Commands issue "RTS <PLID>" followed by "FORCE", then reconnecting the circuit. If that fails, what does a STAT <PLID> show?

Offline ralph

  • Mitel Forums Admin
  • Hero Member
  • *****
  • Posts: 5767
  • Country: us
  • Karma: +469/-0
  • Published Author: http://amzn.to/2dcYSY5
    • View Profile
Re: make busy
« Reply #2 on: January 08, 2013, 10:23:04 AM »
Quote
then in Maintenance Commands issue "RTS <PLID>" followed by "FORCE",

Ace,
Did you mean the command "Busy <PLID>" followed by "force"?

Ralph

Offline acejavelin

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 4099
  • Country: us
  • Karma: +133/-0
  • High-tech, heavy metal redneck!
    • View Profile
    • Like what I do and wanna help out? Send me a donation!
Re: make busy
« Reply #3 on: January 08, 2013, 10:26:54 AM »
Quote
then in Maintenance Commands issue "RTS <PLID>" followed by "FORCE",

Ace,
Did you mean the command "Busy <PLID>" followed by "force"?

Ralph
Don't think so... I assumed it was already in a busy condition from the OP. Although, a BUSY, followed by FORCE, then a RTS might be applicable here.


 

Sitemap 1 2 3 4 5 6 7 8 9 10