200ICP Fails to Fully Load due to PASIC Message Queue Full Error

[dwishop]

Has anyone ever seen this message on a 200ICP during boot?  And if so know a fix?  Thanks!

Service Layer Coordinator SUCCESSFULLY started.

Network Service Layer Coordinator SUCCESSFULLY started.

/ramDisk/  - disk check in progress ...
/ramDisk/  - Volume is OK

          total # of clusters:  32,697
           # of free clusters:  32,695
            # of bad clusters:  0
             total free space:  65,390 Kb
     max contiguous free space:  66,959,360 bytes
                   # of files:  0
                 # of folders:  0
         total bytes in files:  0
             # of lost chains:  0
   total bytes in lost chains:  0
Copy OK: 6332767 bytes copied
12301336/15441920
0x2ba7100 (tPASICRx): PASIC slotID = 11, ReceiveMsg - PASIC Message receive queu
e is full, rc = 0x60000000
0x2ba7100 (tPASICRx): PASIC slotID = 11, ReceiveMsg - PASIC Message receive queu
e is full, rc = 0x60000000
0x2ba7100 (tPASICRx): PASIC slotID = 11, ReceiveMsg - PASIC Message receive queu
e is full, rc = 0x60000000
0x2ba7100 (tPASICRx): PASIC slotID = 11, ReceiveMsg - PASIC Message receive queu
e is full, rc = 0x60000000

[johnp]

Not sure of what modules are installed or whether the cim ports connect to anything but I would try a boot with only the dsp module installed and nothing in any cim port. I may also want to disconnect the analog mainboard. This would be my starting point, slot 11 my refer to the cim ports just comparing to older 200 as to what it would have. I could be wrong.