Author Topic: Replacement 3300CXI not booting up with old i-button  (Read 3266 times)

Offline Northeaster

  • Jr. Member
  • **
  • Posts: 46
  • Karma: +0/-0
    • View Profile
Replacement 3300CXI not booting up with old i-button
« on: November 10, 2010, 12:26:19 PM »
Hi Folks,

I got a replacement 3300CXi controller (old one damaged in shipping) and added the old i-button, t1 card, 512m ram (replacement only came with 256m), APC card and it's hard drive.

The i-button brackets on the replacement chassis, likely refurbished, seemed loose, and did not hold the button tight.  I bent them a bit, so they hold it tighter.

Anyway, I get the following error message from the maintenance port as soon as I apply power: (it doesn't go any further.)  Any ideas??


ERROR - Failed to receive acknowledge during send command:
        I2C Client:   0x50
        I2C Register: 0x05


ERROR - Failed Device Address Write in Read command


M

ERROR - Failed to receive acknowledge during send command:
        I2C Client:   0x50
        I2C Register: 0x05


ERROR - Failed Device Address Write in Read command


M

ERROR - Failed to receive acknowledge during send command:
        I2C Client:   0x50
        I2C Register: 0x05


ERROR - Failed Device Address Write in Read command


M



Offline Northeaster

  • Jr. Member
  • **
  • Posts: 46
  • Karma: +0/-0
    • View Profile
Re: Replacement 3300CXI not booting up with old i-button
« Reply #1 on: November 10, 2010, 01:50:15 PM »
My fault. RAM was not in tight.

Online ralph

  • Mitel Forums Admin
  • Hero Member
  • *****
  • Posts: 5767
  • Country: us
  • Karma: +469/-0
  • Published Author: http://amzn.to/2dcYSY5
    • View Profile
Re: Replacement 3300CXI not booting up with old i-button
« Reply #2 on: November 10, 2010, 03:11:14 PM »
Gotta love the easier fixes.

Ralph
www.univerversity-music-on-hold.com


 

Sitemap 1 2 3 4 5 6 7 8 9 10