Mitel 5340 Setting IP Address

[CBeyer]

How do I do this on these phones? I'm only asked to enter Teleworker Gateway. Nothing more. I have a phone in an offsite location that requires specific IP Address information and I also need to set the location for our Remote IPRC.

What am I missing here? Should be simple, right? Am I entering the wrong configuration on boot up (I'm pressing the 7/8 buttons to get in to programming).

Thanks everyone!

[sarond]

Holding 7 at boot up is for Teleworker config.

I normally hold the '#' button but I believe you can hold down either of the volume buttons as well.
This will allow you to configure the phone.

[bobr1]

You can also hold the “special” or “feature” key during boot up.


Sent from my iPad using Tapatalk

[Tech Electronics]

CBeyer,

It sounds as though you are using old Inter-Tel terminology here so I am not sure if you are working on an Axxess with old Inter-Tel phones that used the 7+8 to program them to look at an IPRC [IP Resource Card] or if you are working on a MiVO-250 with 53xx series phones.

If you are working on an Axxess then the 53xx series phones won't work on it as MiNet phones.

Thanks,

TE