Mitel Forums - The Unofficial Source
Welcome,
Guest
. Please
login
or
register
.
Did you miss your
activation email
?
1 Hour
1 Day
1 Week
1 Month
Forever
Login with username, password and session length
News:
Welcome to Mitel Forums. The Mitel resource - by techies, for techies...
Home
Help
Search
Calendar
Login
Register
Mitel Forums - The Unofficial Source
»
Mitel Forums
»
Mitel MiVoice Business/MCD/3300
»
PRI-Busy Lines
« previous
next »
Print
Pages: [
1
]
Go Down
Author
Topic: PRI-Busy Lines (Read 1718 times)
pakman
Sr. Member
Posts: 483
Karma: +1/-0
PRI-Busy Lines
«
on:
January 17, 2017, 08:44:31 AM »
The following happens from time to time and have not been able to find the root cause.
I will come in and find out the 800 number to our call center is sending out a fast busy when you call it. To resolve the issue I run busy xnet all and then rts xnet all. When looking through the logs it shows traffic congestion report no trunks available between x time and x time. I'm not sure why are trunks go into this state. I have called the vendor and there not seeing any logs on their end and would like me to call to troubleshoot real time the next time it happens. Any other suggestions.
Thanks,
Logged
mszodiac
Sr. Member
Posts: 232
Country:
Karma: +7/-0
Re: PRI-Busy Lines
«
Reply #1 on:
January 17, 2017, 11:02:15 AM »
Can you clarify the problem?
So when you make the call, is it from an MCD that has XNET trunk to the call center, then the call center has the PRI connection?
Before you run the busy xnet all, and rts xnet all, what is the output of state xnet all?
Logged
pakman
Sr. Member
Posts: 483
Karma: +1/-0
Re: PRI-Busy Lines
«
Reply #2 on:
January 17, 2017, 02:35:39 PM »
Don't know the output of state xnet all as I didn't run it this time but believe it shows all lines are busy. I'm calling the 800 number from my cell or any landline will give you the fast busy instead of our greeting. Hope that clarifies it.
Logged
ralph
Mitel Forums Admin
Hero Member
Posts: 5767
Country:
Karma: +469/-0
Published Author: http://amzn.to/2dcYSY5
Re: PRI-Busy Lines
«
Reply #3 on:
January 18, 2017, 06:27:56 AM »
I couldn't tell you the cause but what I'd do is make sure your XNET interPBX routing has fall back routes.
If the route from pbx A to pbx B fails then route the call to PBX C.
I've seen an issue before where a route between systems goes out of service. I could never figure out why.
I worked around the problem by sending the call to a different system and then to the destination pbx. That route would be up so the call would still go through.
Ralph
Logged
Print
Pages: [
1
]
Go Up
« previous
next »
Mitel Forums - The Unofficial Source
»
Mitel Forums
»
Mitel MiVoice Business/MCD/3300
»
PRI-Busy Lines
Sitemap
1
2
3
4
5
6
7
8
9
10