Anyone connected 3300 to Genband C15 Sip Trunks?

[BlackSunshine]

My controller is MXe sw 7.0.  Trying to connect to Genband C15.  Anyone have config they could share?  Any help appreciated!!
I can stat my link state and it says "connected"...however my outbound calls say "access denied" ....inbound get busy after 5 seconds

[ralph]

I just had an issue today where all my trunks were reserved by another peer.
Check that.
Also check COR and peer authentication.

Ralph

[JasonTL]

I have one connected to a Genband CS2K. Should be a similar setup if I can help.

[BlackSunshine]

This is what I get on outbound calls.  Is this what you were talking about Ralph?


2015-10-12  13:12:41 SSP Network->STS
SIP/2.0 406 Service Unavailable-No Ports Available
Supported: 100rel
Via: SIP/2.0/UDP 10.222.0.2:5060;branch=z9hG4bK1877195552-103910528
To: <sip:8667543@[Edit]>;tag=3[Edit]-676909
From: "T.Holman" <sip:[Edit]@10.222.0.2>;tag=0_1877195552-103910529
P-Asserted-Identity: "T.Holman" <sip:[Edit]@10.222.0.2>
Call-ID: 1877195552-103910527
CSeq: 1 INVITE
Allow: PUBLISH,MESSAGE,UPDATE,PRACK,SUBSCRIBE,REFER,INFO,NOTIFY,REGISTER,OPTIONS,BYE,INVITE,ACK,CANCEL
Contact: <sip:8667543@[Edit]:5060>
Content-Length: 0

[ralph]

SIP/2.0 406 Service Unavailable-No Ports Available

That's exactly what I'm talking about.
See if your other peers have reserved all of your SIP trunk licenses.

Ralph

[BlackSunshine]

The current peer is the only one programmed.  I did have a Audiocodes on system for testing at one time but it is removed for sometime now.

[ralph]

Is this for an inbound call or an outbound call?
If it's outbound then you'll have to look to see how many ports are available in the Genband.

Ralph