« previous next »
Pages: [1]   Go Down

Author Topic: Remotely identify cabinet model?  (Read 1584 times)

Offline matthew

  • Full Member
  • ***
  • Posts: 123
  • Country: au
  • Karma: +2/-0
    • View Profile
Remotely identify cabinet model?
« on: May 15, 2015, 02:43:42 AM »
I've been asked to do a remote audit on a site. The software is the oldest I've personally seen: 7.1.4.9_1. Is there a way to tell if it's a CX or whatever?
Logged

Offline sarond

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1404
  • Country: au
  • Karma: +73/-0
    • View Profile
Re: Remotely identify cabinet model?
« Reply #1 on: May 15, 2015, 04:17:17 AM »
Can you get shell access?

If so you can try this.

http://www.mitelusergroup.com/forum/messages.cfm?threadid=009782B1-1422-20FD-2A4DAC6AA0AADF32

There is also a PLATFORMTYPE maintenance command but not sure when it was introduced.
Logged

Offline matthew

  • Full Member
  • ***
  • Posts: 123
  • Country: au
  • Karma: +2/-0
    • View Profile
Re: Remotely identify cabinet model?
« Reply #2 on: August 18, 2015, 07:37:20 PM »
It took a while, but I was eventually able to check this out. I didn't have access to PuTTY, but the PLATFORMTYPE maintenance command did the job, even on such an old version. Thanks. :)
Logged

Pages: [1]   Go Up
« previous next »
 

Sitemap 1 2 3 4 5 6 7 8 9 10