Author Topic: CO Trunk Circuit Description Form  (Read 1292 times)

Offline pakman

  • Sr. Member
  • ****
  • Posts: 483
  • Karma: +1/-0
    • View Profile
CO Trunk Circuit Description Form
« on: September 25, 2014, 01:50:24 PM »
I found some discrepancies under the Loop programming and the analog trunk forms. The Balance Network Setting is set to National Complex and short under the CO Trunk Circuit Des. form but under the Analog trunk forms it's set to 600. I am wondering if these two should match and if so which is the best setting?

Thanks,


Offline x-man

  • Hero Member
  • *****
  • Posts: 1129
  • Country: gb
  • Karma: +25/-0
    • View Profile
Re: CO Trunk Circuit Description Form
« Reply #1 on: September 25, 2014, 02:18:53 PM »
You really need to run the loop tests to get the best results for your line. so you need the milliwatt and silence test numbers or use the loopback method.


 

Sitemap 1 2 3 4 5 6 7 8 9 10