Author Topic: RTC shell command to check NIC settings  (Read 5197 times)

Online ralph

  • Mitel Forums Admin
  • Hero Member
  • *****
  • Posts: 5767
  • Country: us
  • Karma: +469/-0
  • Published Author: http://amzn.to/2dcYSY5
    • View Profile
RTC shell command to check NIC settings
« on: March 28, 2011, 09:03:20 AM »
Here's what I'm looking for:
Is there a RTC shell command that will show what the Ethernet interface is set to?  Such as 1-meg full?

And related:   I there a command to set the port and have it survive a reboot?

Ralph
« Last Edit: April 23, 2014, 04:58:29 PM by ralph »


Offline Mitel100

  • Sr. Member
  • ****
  • Posts: 262
  • Country: gb
  • Karma: +6/-0
    • View Profile
Re: RTC shell command to check NIC settings
« Reply #1 on: March 28, 2011, 10:46:55 AM »
The command is - L2 STATUS PORT 1

You should also be able to statically assign the speed within the L2 switch form. What software version are you running?

Online ralph

  • Mitel Forums Admin
  • Hero Member
  • *****
  • Posts: 5767
  • Country: us
  • Karma: +469/-0
  • Published Author: http://amzn.to/2dcYSY5
    • View Profile
Re: RTC shell command to check NIC settings
« Reply #2 on: March 28, 2011, 11:39:57 AM »
Thanks Mitel100.  That was exactly what I was looking for.

I'm running 4.2.
Just didn't think about the L2 Switch form.  Never found it necessary to change it.
I just became a question because we had some issues with our MBG and our IT director found something on another forum that related to call quality and the L2 port settings.

Ralph
« Last Edit: April 23, 2014, 04:58:16 PM by ralph »

Offline Mitel100

  • Sr. Member
  • ****
  • Posts: 262
  • Country: gb
  • Karma: +6/-0
    • View Profile
Re: RTC shell command to check NIC settings
« Reply #3 on: March 28, 2011, 03:56:35 PM »
I now what you mean. I make it a habit that in my designs I always sipulate how the network requires it settings for ports. Do you have the MSL commands to change the port settings on there? If not I can post them

Online ralph

  • Mitel Forums Admin
  • Hero Member
  • *****
  • Posts: 5767
  • Country: us
  • Karma: +469/-0
  • Published Author: http://amzn.to/2dcYSY5
    • View Profile
Re: RTC shell command to check NIC settings
« Reply #4 on: March 28, 2011, 04:35:48 PM »
Please go ahead and post them.

Thanks.

Ralph

Offline Mitel100

  • Sr. Member
  • ****
  • Posts: 262
  • Country: gb
  • Karma: +6/-0
    • View Profile
Re: RTC shell command to check NIC settings
« Reply #5 on: March 28, 2011, 04:42:47 PM »
No worries, login as root on the MSL and use these Linux commands:

config setprop InternalInterface EthtoolOpts "speed 100 duplex full autoneg off"
signal-event post-upgrade
signal-event reboot


 

Sitemap 1 2 3 4 5 6 7 8 9 10