« previous next »
Pages: [1]   Go Down

Author Topic: Odd alarm  (Read 2739 times)

Offline Mattmayn

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1069
  • Country: vi
  • Karma: +14/-0
    • View Profile
Odd alarm
« on: December 14, 2010, 12:54:09 PM »
Has anyone had a MSP Failure alarm before?

I have one on an Mxe II and I have no idea what that is, no troubles have been reported so it must not be too serious.
Logged

Offline v2win

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 628
  • Country: us
  • Karma: +11/-0
    • View Profile
Re: Odd alarm
« Reply #1 on: December 14, 2010, 01:24:48 PM »
I "think" its a DSP alarm
Logged

Offline MitelUK2010

  • Sr. Member
  • ****
  • Posts: 201
  • Country: gb
  • Karma: +0/-0
    • View Profile
Re: Odd alarm
« Reply #2 on: December 14, 2010, 02:06:35 PM »
MSP failure is when the status of the fans, power supply and temp of system is compromised. Resolution- use reset system command, watch system start to boot and then power it off. Leave for 30 seconds and power back up. Should clear alarm..... If not then swap out I reckon.
Logged

Offline Ray B

  • Contributer
  • *
  • Posts: 13
  • Karma: +0/-0
    • View Profile
Re: Odd alarm
« Reply #3 on: February 11, 2011, 12:43:04 PM »
I had the same problem recently when installing a MXeIII running MCD 4.2. I contacted product support and they gave me a couple of commands to run.

From the RTC shell you need to type this command
 g_ForceBootromUpgrade =1
 
Once that is done type thw following command in ESM maintenance commands 
 UPGRADEBOOTROM ALL

good luck!
Logged

Offline Mattmayn

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 1069
  • Country: vi
  • Karma: +14/-0
    • View Profile
Re: Odd alarm
« Reply #4 on: February 11, 2011, 01:39:10 PM »
Tried that, turned out to be hardware failure.
Logged

Pages: [1]   Go Up
« previous next »
 

Sitemap 1 2 3 4 5 6 7 8 9 10