Looking for MBG 6.1.10.0 ISO

[llars]

I have a customer with a 200ICP and a Teleworker server and the Teleworker server crashed. I am building a new server and I have MSL 9.2.25.0 loaded and it is synced with AMC, however the Blades page will not update with the list of MBG blades to download. I think the last time I went through this process with a customer was in 2017 and I had no issues.

To my knowledge, MSL 9.2.25.0 / MBG 6.1.10.0 is the last working combination for Teleworker on a 200ICP. I am pretty sure I have tried getting a 200ICP to work with MBG 7 and MBG 8 but I had no success.

I logged into Mitel Online but the oldest MBG I see listed is 8.1.25 running on MBG 10.1. Does anyone happen to have the 6.1.10.0 Blade ISO they could provide?

[dilkie]

Why wouldn't the latest MBG work with the 200? As far as I know it does. It should.

[llars]

When I tried 7.0 and 8.0 last I could not get them to work on a 200 ICP. 3300 Has never been an issue. The 200 is EOL so Mitel probably dropped support. Maybe MBG 10 added support back in as I haven't tried it. I'd have to look at the Engineering docs. The other problem with trying out different versions is every time I have to clear the hardware ID then call AMC to release the record because the Hardware ID has been cleared too many times.

[llars]

I just went through the Installation guides for 10.1, 9.1, 8.1, 7.1, and 6.1 and the only one that lists support for the SX-200 is 6.1 which falls in line with my testing. From 7.0 onward only the 3300 and 5000 are supported in MBG.

[dilkie]

ignore the guide, it would only list non-MDed products... There should be no reason why the 200 wouldn't work, it's the same protocol for the same sets that the 3300 uses.

what specifically didn't work when you tried?

[llars]

It's been a number of years since I last tried but it had something to do with configuring the ICP under Border Gateway.

In any event I was able to pull the RPMs off a different running server and cobble together a Blade CD and I was able to get 6.1 installed onto the new server so I'm good.

[dilkie]

well, yes, the "200ICP" icp type has disappeared but in all honesty... that setting was only informative... if you used 3300 it would still work.

[dilkie]

it's just that you're running old, outdated, and insecure versions of msl and mbg.

[llars]

Next time I have to rebuild a MBG for a 200ICP I'll try getting it to work with the current release.


Thanks.