Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jimmut

Pages: [1]
1
Mitel MiVoice Business/MCD/3300 / Re: Multicall button Behavior and Caller ID
« on: September 02, 2011, 01:23:16 PM »
I am now asking them is i possible to make the the phone use one of the multicall buttons when you pick up and dial or just dialing an extension verse it using the primary button. That way we can see the caller ID of another call coming in. Don't know if its possible but would be one way around this very obvious problem with these phones.

2
Mitel MiVoice Business/MCD/3300 / Re: Multicall button Behavior and Caller ID
« on: September 01, 2011, 10:33:48 AM »
I have a 5330 phone. I am new to the system. I guess ICM was just a label for Intercom..That is the way we had additional lines labeled on our old Norstar system. I guess they are just multicall buttons. Thanks Mattmayn for the information. So it sounds like that is just the way it behaves as to labeling on the multicall verse prive buttons.

Question say you are on a multicall line and another call comes in you get caller ID displayed at the top of the phone...but what if you are on the prime number...do you get called ID displayed at the top...We don't.

3
Mitel MiVoice Business/MCD/3300 / Multicall button Behavior and Caller ID
« on: August 31, 2011, 09:09:20 AM »
Our reps say there is no way to make this work correctly but I think there has to be a way. At the bottom of the phone we have three buttons...top two are labeled ICM (multicall??) and bottom one is our 4 digit extension. When a call comes in and we answer it ...the extension number changes to the callers ID. If another call comes in we can't see who is calling..But say a call comes in and I press a ICM (I guess this is multicall button) button...next call comes in I can see who it is.

Also when I answer on my extension button it changes to display the caller...but if I answer on an ICM (multicall) button it doesn't change to display the caller. We would like all three buttons to be able to display the caller when answered and display the next call coming in when already on a line.

Pages: [1]