Messages

1

Mitel MiVoice Business/MCD/3300 / Re: Added L2 Switch IP and System is not reachable anymore

« on: July 07, 2011, 12:14:22 PM »

Also BOTH the L2 and MXe IP Address become non reachable.

What changes when inputing the L2 Address??? - is there a way to remove the L2 addres.....if i try and put it back to 0.0.0.0 and reboot it comes back with the 192.168.x.x address again....i can't seem to get rid of it...

2

Mitel MiVoice Business/MCD/3300 / Re: Added L2 Switch IP and System is not reachable anymore

« on: July 07, 2011, 12:10:14 PM »

Seems very coincidental that it would be a dup ip. - even if it was normally i should recieve a PING response from whatever device, may not be the correct device but one or the other should respond.

Another update is that if i plug into 2nd port on the front of the MXe i can ALWAYS reach the system....only when i plug into my network switches i can't reach the MXe, until i reboot it and then i can only reach it for ten or so minutes.....please keep in mind this ONLY started happening right AFTER i changed the L2 Switch IP from 0.0.0.0 to 192.168.X.X.

3

Mitel MiVoice Business/MCD/3300 / Added L2 Switch IP and System is not reachable anymore

« on: July 07, 2011, 11:05:41 AM »

Everything was working great, i changed the IP of the L2 Switch from 0.0.0.0 to an internal IP and rebooted....system came up and i could ping/reach it....after 10 minutes i cant reach it anymore....i reboot the system (through the console) and i can reach it for another 10 minutes and then it stop responding again....everytime i reboot it it works for about ten minutes and then stops.

I can't change the L2 Switch IP back to 0.0.0.0, everytime i try and reboot it it always comes back with the old IP 192.168.X.X.

The Voice Vlan is Set for 2 and the two front ports are both untagged.....as i said before everything was working perfectly fine before i changed the L2 Switch address.....any ideas?