Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Emrah Hatem

Pages: [1] 2 3
1
Mitel MiVoice Business/MCD/3300 / Re: Caller ID for analog trunk
« on: May 04, 2011, 03:28:11 AM »
embedded trunk card

2
Mitel MiVoice Business/MCD/3300 / Re: Caller ID for analog trunk
« on: May 03, 2011, 02:20:24 AM »
analog-LS trunk

3
Mitel MiVoice Business/MCD/3300 / Re: caller ID does not work
« on: May 02, 2011, 09:55:05 AM »
yes Ralph,we are getting caller ID

4
Mitel MiVoice Business/MCD/3300 / Re: Caller ID for analog trunk
« on: May 02, 2011, 07:23:33 AM »
I did and number and name are coming.So what did I forget to configure ?

5
Mitel MiVoice Business/MCD/3300 / Re: caller ID does not work
« on: May 02, 2011, 07:19:24 AM »
I have analog trunk but still could not get Caller ID...

6
Mitel MiVoice Business/MCD/3300 / Re: Ringing for dropped calls
« on: April 27, 2011, 03:26:29 AM »
not working   :-\

7
Mitel MiVoice Business/MCD/3300 / Re: Ringing for dropped calls
« on: April 26, 2011, 02:28:00 AM »
donovan,as far as I know that it does not have disconnect supervision.


8
Mitel MiVoice Business/MCD/3300 / Re: Ringing for dropped calls
« on: April 26, 2011, 02:26:55 AM »
Number   1
   
Line Start Type   NO
   
Post Call Metering   NO
   
Guard Timer   800
   
Calling Party Disconnect   NO
   
Dictation Trunk   NO
   
Ignore Far-End Disconnect   NO
   
Disconnect Timer   500
   
Ignore Far End Reversal During Seizure   YES
   
Ringing Expected   YES
   
Seize Timer   10
   
Address Signaling   DTMF
   
Fake Answer Supervision After Outpulsing   YES
   
Ignore Answer Supervision   YES
   
Release Supervision Expected   YES
   
Audio Inhibit Until Answer Supervision   YES
   
High Loss Option   NO
Balanced Network Setting   National Complex
   
Trunk Category   Short
   
Perform seize test on out-of-service trunks   YES
   
Ground Condition   Removed
During Busy Out   
First Meter Pulse Is Answer   NO
   
Minimum Ring   300
Detection Timer   
Drop Digit Rcvr for Outgoing Audio Before Ans Sup   NO
   
Flash Timer   300
   
Call Clearing Signal   Disconnect
   
AC Impedance   National 
   
CLASS Trunk   YES
   
Central Office Milliwatt Number   
   
Central Office Silence Number   




9
Mitel MiVoice Business/MCD/3300 / Re: Ringing for dropped calls
« on: April 25, 2011, 04:51:19 AM »
Any idea?

10
Mitel MiVoice Business/MCD/3300 / Re: Ringing for dropped calls
« on: April 22, 2011, 03:15:22 AM »
?

11
Mitel MiVoice Business/MCD/3300 / Re: Ringing for dropped calls
« on: April 21, 2011, 03:19:52 AM »
just analog trunks

12
Mitel MiVoice Business/MCD/3300 / Re: Ringing for dropped calls
« on: April 20, 2011, 09:52:10 AM »
Hi ralph,
I entered most of the values for both disconnect timer and flash timer according to the following sentence which is in the HELP ;
"This timer( disconnect timer ) must be longer than the Flash Timer "
But it is not working ? Do you think that I have also to change some other values ?

13
Mitel MiVoice Business/MCD/3300 / Re: Increasing volume for dect
« on: April 20, 2011, 06:15:47 AM »
thank you brantn :)

14
Mitel MiVoice Business/MCD/3300 / Re: Increasing volume for dect
« on: April 19, 2011, 02:35:10 AM »
Any idea ?

15
Mitel MiVoice Business/MCD/3300 / Re: Ringing for dropped calls
« on: April 18, 2011, 03:58:01 AM »
Any info will be helpfull

Pages: [1] 2 3