Messages

1

Mitel MiVoice Business/MCD/3300 / Re: Moving Virtual MSL (Linux)MiCollab Boarder Gateway/Teleworker Server to new Host

« on: September 29, 2020, 08:31:54 AM »

Just to update - I moved the MiCollab virtual server to a different hyper v host, it was assigned MAC addresses dynamically, but everything worked fine - obviously I had to assign nic's.. It kept it's IP and apparently, in this case, the MAC address changing didn't affect anything.  Thanks much for the help.

2

Mitel MiVoice Business/MCD/3300 / Re: Moving Virtual MSL (Linux)MiCollab Boarder Gateway/Teleworker Server to new Host

« on: September 25, 2020, 03:38:59 PM »

Yes, I get that - thank you.  I was hoping NOT to have to assign a static MAC in Hyper V.. I worry that the older server (that this is moving off of) might give it out again.  Thanks again to everyone for the quick and precise responses. 

3

Mitel MiVoice Business/MCD/3300 / Re: Moving Virtual MSL (Linux)MiCollab Boarder Gateway/Teleworker Server to new Host

« on: September 24, 2020, 06:13:27 PM »

Hi, thank you so very much for this.  Assuming I have to make the MAC static, can that be done in the little Mitel "gui" (when you sign in with Admin) or should I use some kind of Linux editor and sign in with Root?

Or, better yet, can it be done in the Mitel UI after it's booted up, etc?

I'm a little nervous about doing a Live Migration with this server.  Everyone's remote these days - lots of Teleworkers! 

Thank you again.  Maggie

4

Mitel MiVoice Business/MCD/3300 / Moving Virtual MSL (Linux)MiCollab Boarder Gateway/Teleworker Server to new Host

« on: September 24, 2020, 01:07:25 PM »

I need to move my virtual Border Gateway/Teleworker server to a different Hyper-V host.  I need it to keep the same Static IP, which I'm thinking it will - since it's in the configuration (which I can go in and check after the move).    However I have had issues moving other Linux Servers (not Mitel Related) where we've had to go in and set the MAC address.  If that might happen to me here, I would like to be prepared as to how to do that.  It may differ based on the Linux Version.

Any thoughts welcome.  Thank you.