Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - scottai

Pages: [1]
1
Thanks for the info everyone.  I suspected that was the case as every internet hit I found that said that was related to 5000/250, but I wanted to be sure.

I will stick a switch in front of the router, or look into a bridging config for it.

2
I'm trying to setup a Mitel 5220 IP phone (not using SIP) to work through a NAT (ubiquiti Edgerouter X).
I've forwarded the ports, and it can make and receive calls fine, but it doesn't receive call audio.

Internet searching shows I need to go to System\Devices and Feature Codes\Phones\Specific Phone\IP Settings and change the 'NAT Address Type' to 'NAT' for that phone,
but I can't find any NAT address type options in the system.

Is it possible to run a 5220 using Minet through a NAT?

I'm Running MiVoice Business  8.0 SP3 PR3 on a 3300 MXe-III

Pages: [1]