Messages

1

Mitel MiVoice Business/MCD/3300 / default destination for incoming calls

« on: February 28, 2023, 01:52:50 PM »

hi everyone,
i have a mitel 3300 with a pri line
i have configured  DIDs , then for exemple the external number 055 8080399 is forwared to the extension 399,
055 8080390 is forwarded to 390 etc...
the question is how can i forward all the externals numbers that not match any extension ,to a specific extension (the same for all) without writing them one by one in did service form.
thanks for help

2

Mitel MiVoice Business/MCD/3300 / Re: Auto Attendant destination.

« on: February 14, 2023, 02:49:00 AM »

no, i'm not using NuPoint.

3

Mitel MiVoice Business/MCD/3300 / Auto Attendant destination.

« on: February 13, 2023, 01:33:26 PM »

Good evening,
I took over a 3300ax controller from another technician, and I saw that external calls are directed to a hunt group that plays you a message and, based on your dialed number, forwards you to extensions.
I saw that in the "vm mailboxes" menu I can decide where to send the call based on the number dialed.
after the end of the message, even if you don't dial anything, the call is forwarded to an extension and I can't find where it is possible to change this extension number.
Thanks for your help

Transfer only mailboxes act like that. Might want to check in the Voicemail > VM Mailboxes form.

4

Mitel MiVoice Business/MCD/3300 / Re: Problem with system upgrade

« on: July 31, 2019, 11:37:23 AM »

other : FixPartition



(attached)

This command isn't present in MiVB 9.x.x.x consolle because it's different from the 8.x.x.x one .

5

Mitel MiVoice Business/MCD/3300 / Re: Problem with system upgrade

« on: July 30, 2019, 11:53:38 AM »

try to reset your hard drive with the command FixPartition , then reinstall the V9

thanks for your advice but i can't find the command FixPartition all the command i see are in the attachments , can i reset my hard drive in any other way ?

6

Mitel MiVoice Business/MCD/3300 / Problem with system upgrade

« on: July 30, 2019, 05:10:28 AM »

Hi everyone, i have a problem with the firmware upgrade of the 3300 cxi II controller, last month i've succesfully upgrade the firmware from the MiVB 8.x to the 9.0.x.x using the migration tool and everything works fine. Last week I've tried to log in to the controller but after many times that i can't get in I decide to reset the system software using conosolle commands. Then i have try many times to reinstall MiVB 9.0.x.x ( i've tried different versions) but every time i got the error showed in the pic , for the system install i use commands in the other pic , from TFTPD64's sys log i see that everything is ok so the system software is correctly put on the controller but everytime i got the same error , I hope someone can help me.