Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - brantn

Pages: [1] 2 3 ... 18
1
In case there is any others out there that had issues with Lync and LBG check if you have a collo mediation server on your front end server. This creates and issue with LBG on port 5060 and the easy fix is to change it so LBG is using TLS on 5061.

2
Mitel MiVoice Business/MCD/3300 / Re: Mitel 3300 Voicemail to Email
« on: December 29, 2011, 05:29:12 PM »
What version of Exchange? You will want to look at your receive connector in hub transport. You might have a relay restriction setup from the old ip and it just needs to be updated.

3
Mitel MiVoice Business/MCD/3300 / Re: ICP 3000 version 9
« on: December 09, 2011, 11:45:11 AM »
I would greatly suggest upgrading to MCD as there is a lot of changes to SIP. It depends on call compression but roughly 80k.

4
Non-Mitel Chatter / Re: No Overtime for IT Wokers
« on: December 09, 2011, 11:39:48 AM »
So what is going to happen when all the IT people leave the virus sitting at 5 when they hit their 8 hours? I know my family will enjoy seeing more of me.

5
I would verify the setup guide on MOL paying close attention to COS options. You also need to make an incoming DID SIP Peer profile assignment for your subscriber access number. Restart the services and try again.

I have run across this multiple times. Try those and repost I will post my options if needed after that.

6
Yes you should see a reregister log I believe sounds like it is set for an extreme period of time at the vendor probably to minimize extra network traffic on their end. You should also see it by doing a sip capture.

7
1.) I would venture to say that Broadvox made some change on their SBC or 2 some other device is trying to use the account info those are the only times I have seen a registration issue outside of network/hardware issues.

2.) It does try again depending on heartbeat time set by the provider and controller depending on when it is set to reregister 60 minutes or so on. By editing the form you are simply forcing the reregister.

8
Mitel MiVoice Business/MCD/3300 / Re: DTMF pass through possible?
« on: November 25, 2011, 04:43:22 PM »
Might want to play around with Simulated ISDN Progress in the COS of the trunks as well as QSIG Diversion in system options I have seen this affect DTMF from SIP to TDM.

9
Mitel MiVoice Business/MCD/3300 / Re: Mitel 3300 Solid State Drives -(SSD)
« on: November 22, 2011, 04:24:00 PM »
Most definately when you figure the amount of traditional drives replaced to my 1 SSD that makes it a no brainer.

10
Mitel MiVoice Business/MCD/3300 / Re: Mitel 3300 Solid State Drives -(SSD)
« on: November 18, 2011, 08:54:59 PM »
Yes I have had one fail was one in a million chance and was towards the beginning of them being packaged in controllers.

11
Mitel MiVoice Business/MCD/3300 / Re: 3300 Mxe 111 - rebooting
« on: November 17, 2011, 04:26:42 PM »
To me it appears to be a hardware issue I would strip out all the extra modules and see if it boots. Appears as Ralph said might be the mainboard in the controller.

12
Mitel MiVoice Business/MCD/3300 / Re: Mitel 3300 using Free 411
« on: November 17, 2011, 04:22:17 PM »
Ah very true good way to cut some costs.

13
Mitel MiVoice Business/MCD/3300 / Re: Mitel 3300 using Free 411
« on: November 17, 2011, 11:42:43 AM »
Good work you shouldn't need all the area code entries in your ars as anyone dialing 9-1-Area Code-5551212 is already routed that way with 91XXX5551212.

14
Mitel MiVoice Business/MCD/3300 / Re: 3300 Mxe 111 - rebooting
« on: November 17, 2011, 11:38:02 AM »
If that is the problem it is a possibility. I would still look at the maintenance dump and see for sure what is causing the reboot. Could easily be a module as Ralph suggested.

15
Mitel MiVoice Business/MCD/3300 / Re: Wireles IP or SIp Phones
« on: November 16, 2011, 05:42:11 PM »
Mitel makes a series of Wireless DECT phones. Guess I am confused on what the question is.

Pages: [1] 2 3 ... 18