Messages

1

Mitel SX200, SX2000, and older SX platforms / Re: Mitel SX-200 ICP PRI and Start Codes

« on: July 10, 2020, 10:44:22 AM »

Thanks for the suggestions and information guys! Unfortunately, Johnp is correct. I have tried using ** in the digits to be inserted and it just ignores it when sending it out over the PRI. I'll work to update the Asterisk dialplan to allow for that to make everything work.

Thanks,
Daniel

2

Mitel SX200, SX2000, and older SX platforms / Mitel SX-200 ICP PRI and Start Codes

« on: July 05, 2020, 07:33:36 PM »

Hello,

I have an SX-200 ICP with a PRI that ties to an Asterisk system at another location for extension to extension dialing. I need to be able to send star codes over the PRI from the Mitel to access a couple of feature codes on the Asterisk such as intercom. When I try to dial the route access code plus *80 and the extension number only 80 plus the extension number is sent across. I have checked to make sure that the route is set to only delete one digit, which it is. Any ideas on how to make this work?

3

Mitel SX200, SX2000, and older SX platforms / SX-200 ICP and SimpleSMDR

« on: March 05, 2020, 05:28:57 PM »

Has anyone been able to successfully setup SimpleSMDR to work with the SX-200 ICP? I currently have SMDR being captured by a terminal that writes it to a log, but it would be great to get the SimpleSMDR software working with it. I have loaded the VMware file but was having a little trouble on the initial setup page under system type. Also, are there any specific options in the 200 that need to be set to output in the correct format for it?

Thanks,
Daniel

4

Mitel SX200, SX2000, and older SX platforms / Re: Mitel 5330e and SX 200 - Outgoing calls Access Denied

« on: September 25, 2019, 10:35:27 PM »

In form 9 check to see if the COS and COR are the same as other sets that are working as expected.