Messages

1

MiVoice Office 250/Mitel 5000 / Re: MiVoice 250 JTAG Error

« on: October 01, 2018, 06:10:20 PM »

Well it wasn't an upgrade of the software only a database upload. Even in this scenario it has been known to cause these errors? There's no fix or way to update whatever is messed up?

2

MiVoice Office 250/Mitel 5000 / MiVoice 250 JTAG Error

« on: October 01, 2018, 04:35:05 PM »

I built a database in a local mode and went to upload it and once it finished, the system rebooted with a JTAG failure. Everything was fine until I did this. If you select "YES" and go past the JTAG  boot failure it goes into a preboot and then booting and then JTAG failure again. Select "YES" to move forward again it does the reboot and then booting and then gives you an "upgrade FPGA ENTER ANY KEY". Once you hit the button to start it, it says starting to upgrade the fpga and then says failure, goes through 10 attempts and says replace the motherboard. It's obviously looking for something to grab and install. Is this a software that needs to be done through a USB port? Again, this didn't happen until I loaded a local database and it worked fine until that was done. This is a new unit not a used one.