Messages

1

SIP On Mitel / Re: Mitel 3235

« on: December 05, 2017, 05:59:33 PM »

Do you mean Mitel 5235 phone? Those are MiNet devices, not SIP, they are proprietary and only work with Mitel phone systems.

Can you verify the model and/or part number of the phone?

Sent from my Moto G (5) Plus using Tapatalk

I dunno about the Phone or SIP part, Just says on the screen MITEL 5235 IP Phone

 Label on back is layed out and looks like this:

MITEL 3235 IP PHONE 500004310
This device complies.......
................................................. ..
...And so on...
                        -------------
56006460 REV /B.12 (10)/
                        -------------

Upon searching google for 56006460 is does pop up with my phone.

Thankyou!

Yup... Mitel proprietary set by default using MiNet protocol. You can flash it to SIP but that firmware was discontinued almost 10 years ago and is unsupported.

No offense, I love Mitel stuff but you would be better off finding a used Polycom 450 or Aastra 6755 (55i) on eBay for like $25, they are well supported on most SIP platforms... You will hate using a Mitel in SIP mode.

Sent from my Moto G (5) Plus using Tapatalk

Ok thanks for the info.
So before I scrap my idea then what kind of thing should I try and what would this allow me to do?
Im completely new to phones etc. lol

2

SIP On Mitel / Re: Mitel 3235

« on: December 05, 2017, 05:42:20 PM »

Do you mean Mitel 5235 phone? Those are MiNet devices, not SIP, they are proprietary and only work with Mitel phone systems.

Can you verify the model and/or part number of the phone?

Sent from my Moto G (5) Plus using Tapatalk

I dunno about the Phone or SIP part, Just says on the screen MITEL 5235 IP Phone

 Label on back is layed out and looks like this:

MITEL 3235 IP PHONE 500004310
This device complies.......
................................................. ..
...And so on...
                        -------------
56006460 REV /B.12 (10)/
                        -------------

Upon searching google for 56006460 is does pop up with my phone.

Thankyou!

3

SIP On Mitel / Mitel 5235

« on: December 05, 2017, 04:25:30 PM »

Hello everyone, first off sorry if this is in the wrong section, new to this forum.
So I have aquired a Mitel 3235 IP Phone from my uncle, he works in a home office.
Didn't have anything other than the phone, so ive made a power over ethernet cable and connected it to the lower ethernet port looking face on from rear with ethernet ports on right.
Connected to my router.
Phone has powered up and hangs at DHCP Discovery and then finally ticks over to DHCP Timeout before restarting that process again.
Now am I right in thinking I can just setup a PC running Asterisk PBX and all that for it to work or do I need some voip adapters etc?
New to IP phones, would be nice to make use out of this phone.
For my idea for Asterisk PBX I got from a website telling how to setup some VOIP phones so? would that method work with this Mitel 3235?

--------------------------
Info I know:
DHCP Discovery and hangs for five mins before timing out
Boot ver: 02.05.00.05
On a 1.9.168.0.XXX I.P address, Or at least should be, thats what both my PC and Server PC are connected to router wise.
---------------------------
Im thinking it is supposed to be 24v? googled for some adapters some say 40v, others say 24v but cant find an exact mach to this model, not that i'd buy one anyway, After all I got my electrical skills to make one - Like I did.
So I got a standard 24v DC PSU, cut into blue/blue-white and brown/brown-white and powers up, had a moment for about 4 hours where it would cut out then restart and die again, then repeat but its stopped doing that again.

Any advice at all appreciated!

kyle